The MT1115 is a continuous mode inductive step-down converter, designed for driving single or multiple series connected LEDs efficiently from a voltage source higher than the LED voltage. The device operates from an input supply between 6V~50V and provides an externally adjustable output current of up to 1A.
The MT1115 includes the output switch and a high-side output current sensing circuit, which uses an external resistor to set the nominal average output current.
Output current can be adjusted below the set value, by applying an external control signal to the 'ADJ' pin.
The ADJ pin will accept either a DC voltage or a PWM waveform. Depending upon the control frequency, this will provide either a continuous or a gated output current. The PWM filter components are contained within the chip.
The PWM filter provides a soft-start feature by controlling the rise of input/output current. The soft-start time can be increased using an external capacitor from the ADJ pin to ground. Applying a voltage of 0.2V or lower to the ADJ pin turns the output off and switches the device into a low current standby state.
The device is assembled in a SOT89-5 pin package.
Simple low parts count
1A output current
Single pin on/off and brightness control
using DC voltage or PWM
Internal PWM filter
Unique frequency Jitter technique to reduce EMI
High efficiency (up to 97%)
Wide input voltage range: 6V to 50V
Up to 1MHz switching frequency
Inherent open-circuit LED protection
Typical 2% output current accuracy
Low voltage halogen replacement LEDs
Low voltage industrial lighting
LED back-up lighting
On your account or prepay
30 Days Service
Solution & Support
Call +86-191 2935 1516